例句與造句

1. 3 . accomplished the hardware design of intermediate frequency signal processing 4 . accomplished the software design of intermediate frequency signal processing
   3 .完成了中頻信號處理的硬件設計。 4 .完成了中頻信號處理的軟件設計。
2. In the digital intermediate frequency project , the intermediate frequency signal is converted to digital signal directly into the dsp chip , then it is be processed by dft
   數字中頻方案將中頻信號直接通過a / d轉換后送入dsp芯片進行dft變換，最后得到待測信號頻譜的采樣序列。
3. By analysis of the intermediate frequency signals which through eight antennae and receiver channels , eight channels radio spatial spectrum direction finding system can reach the purpose of finding radio direction
   八通道無線電空間譜測向系統通過分析經過八路天線和接收機通道以后的中頻信號達到確定無線電信號方向的目的。
4. In this thesis , aimed at the above - mentioned two - side problems , based on analyzing the theory of lfmcw radar ranging deeply , we implement the work of intermediate frequency signal processing
   本論文針對上述兩方面的問題,在深入分析lfmcw雷達測距理論基礎上,在工程上完成了一部8mm毫米波線性調頻連續波測距雷達的中頻信號處理工作。
5. Due to the hardware characteristic ' s limitation , such as the poor speed of a / d , d / a conversion and dsp process , the most part of sr system adopt middle course . that is to say , by using the special digital converter or running relevant arithmetic , it converts the radio signal to intermediate frequency signal and completes the base - band signal process that is n ' t the veriest sr and is named " software defined radio ( sdr ) "
   由于受到硬件性能如a d 、 d a及dsp芯片處理速度的限制，目前的軟件無線電系統多采用折中的實現方案，增加專用的數字變頻器或者運行數字變頻算法，將射頻信號變頻到中頻，然后再進行基帶信號處理，這樣的軟件無線電系統又被稱之為“軟件定義無線電” ，它并不是真正意義上的軟件無線電。
6. It's difficult to find intermediate frequency signal in a sentence. 用intermediate frequency signal造句挺難的
7. On the basis of the theory of software radio , this paper discusses how to design and develop a realtime digital signal processing system in graphic programming language on a universal hardware workbench of digital signal processing aiming at satellitic intermediate frequency signal
   本文論述了基于軟件無線電思想，在一個通用的數字信號處理硬件平臺上，針對衛星中頻信號，用美國國家儀器公司提供的開發虛擬儀器的labview平臺研制開發了一個實時的數字信號處理系統。
8. Simulator presented in this paper provides a direct interface for the test of shortwave communication system , which well represents various features of hf channel such as multi - path delay , rayleigh fading , doppler shift , doppler spread , gaussian noise and impulsive interference , etc . in order to realize the channel simulation for the intermediate frequency signal , we , inspired by the idea of soft - defined radio , bring forward a new design method that the channel simulator consists of several dsp chips
   本文研制的仿真器提供接口直接對短波通信系統進行測試,能夠全面反映短波信道的多徑時延、瑞利衰落、多普勒頻移、多普勒擴展、高斯噪聲和脈沖干擾等特性。為了實現對中頻信號的信道仿真,開發出一個結合軟件無線電思想的由多個數字信號處理芯片構成的短波信道物理仿真器。
9. The radio frequency receiver supports interface for instrument and base station and air interface for mobile station , and it takes the task of magnifying low noise and down - convert and digital baseband processor filtering and magnifying intermediate frequency to reverse link signal . the digital baseband processor samples the received signal after down - convert radio frequency signal to intermediate frequency signal and processes other processing and supports interfaces to computer , next sends data to computer . the gps receiver supports interface for instrument and gps system , and receives gps system signal , next it demodulates the correlative information and sends out benchmark clock signal we need
   射頻接收部分主要為儀器和基站、移動臺提供空中接口,其主要任務是在反向鏈路上對接收到的射頻調制信號進行低噪聲放大、射頻下變頻變換、中頻濾波放大等;數字基帶部分為對接收信號變頻為中頻后進行a / d采樣,以及其他的rsp處理并和計算機提供接口,將數據送至計算機進行后臺處理、顯示等; gps接收機部分為儀器和gps系統提供接口,接收gps系統信號并解調相關信息,輸出所需的電文及時鐘基準信息等。
10. This thesis deals with design and application of a multiprocessor made of four dsps in monitoring receiver . the broadband monitoring receiver requires a kind of chip with high performance because of complicated intermediate frequency signal processing . the author selects a kind of digital signal processor called adsp21160 . during the process of design , the author uses cpld , fpga and some special cpus to finish signal , processing in the monitoring receiver . cluster multiprocessor based on vxibus made of four adsp21160 is put forward . the task distribution of four dsps is solved too . furthermore , data transition methods between chips at a high speed through link ports and chip extension mode using external port are recommended . the author debugs , emulates the program in one adsp - 21160 ez - kit lite and simulates the multiprocessor program in visualdsp + +
    本文主要探討了監測接收機中多dsp處理模塊的設計與應用，寬帶監測接收機的中頻處理數據量大、實時性高，這樣，對dsp芯片提出了很高的要求，作者通過比較選擇了最適用于監測接收機的數字信號處理器adsp21160 ，并結合使用了cpld 、 fpga以及一些專用的cpu來完成監測接收機中的數據處理。作者提出了由四片adsp21160組成的簇式多dsp處理模塊的結構并配以了vxi總線，論述了簇式結構的特點，解決了多dsp處理模塊中四片adsp21160的任務分配問題。
11. When the cur - cuit resets , the chip remains accepting state , works in burst mode , and adopts dpsk modulation mode . it proceeds quadrature - sampled intermediate frequency signal after the ad9057 has converted , then down - converses , despreads and demodulates . the demodulated baseband signal will be sended into scm to dispose through interrupt
    上電復位后，芯片處于接收狀態，工作在突發模式下，采用dpsk調制方式，將ad9057轉換完的中頻信號進行復正交取樣后下變頻、解擴、解調，通過中斷將解調完的基帶信號送入單片機處理；處于發送狀態時，可將數據擴頻、調制，經ad9768送出。
12. In this thesis , a kind of software method is researched to realize the functions of fast acquisition , tracking and demodulation of pcm - cdma - bpsk intermediate frequency signals . conventional research on spread spectrum signals is in the case of ideal conditions , such as low code rate , narrow dynamic range , narrow frequency - changing range and so on
    本論文將介紹一種軟件模擬硬件的方法來實現pcm - cdma - bpsk中頻信號的快捕、跟蹤和解調。關于擴頻信號的傳統的研究是在理想的條件下，比如低碼率、窄動態范圍、窄頻率變化范圍等等。
13. A / d samples the intermediate frequency signal . the digital signal proceeding part based on tigersharc dsp can process the baseband digital signal including the algorithm of baseband modulation , baseband differential detection and symbol synchronization , etc . digital up converter supports interpolation filter and complex mixer
    A / d對中頻信號進行采樣,數字信號處理部分以tigersharcdsp為核心,負責基帶采樣數字信號的處理,實現基帶信號調制,基帶差分解調,符號同步的捕獲和跟蹤等算法。
14. In the analog intermediate frequency project , the signal to be measured is converted to be a fixed intermediate frequency signal , which then is demodulated , logarithm amplified and detected to be a dc signal that can reflect the original signal strength . after passing the a / d converter , it will be processed by microcontroller in software
    模擬中頻方案將待測信號變頻到固定中頻上，對信號進行解調、對數放大、檢波后，輸出反映待測信號強度的直流信號，通過a / d轉換送入單片機進行軟件處理。